Dlp-G122 Download An Alarm Severity Profile - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G122 Download an Alarm Severity Profile

Step 16 Return to your originating procedure (NTP).
DLP-G122 Download an Alarm Severity Profile
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
To access the alarm profile editor from network view, click the Provisioning > Alarm Profiles tabs.
Step 1
Step 2 To access the profile editor from node view, click the Provisioning > Alarm Profiles >
Alarm Profile Editor tabs.
To access the profile editor from a card view, click the following tabs:
Step 3
•
•
•
•
•
•
•
Click Load.
Step 4
If you want to download a profile that exists on the node, click From Node in the Load Profiles
Step 5
dialog box.
a.
b.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
7-22
This task downloads a custom alarm severity profile from a network-drive
accessible CD-ROM, floppy disk, or hard disk location.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
If the card is an MXP, MXPP, TXP, TXPP, or WSS card, click the Provisioning > Alarm Profiles
> Alarm Profile Editor tabs.
If the card is an OSC-CSM card, click the Provisioning > OC3 Line > Alarm Profiles >
Alarm Profile Editor tabs or the Provisioning > Optical Line > Alarm Profiles >
Alarm Profile Editor tabs.
If the card is a 32MUX-O or 32DMX-O card, click the Provisioning > Optical Line >
Alarm Profiles > Alarm Profile Editor tabs or the Provisioning > Optical Chn >
Alarm Profiles > Alarm Profile Editor tabs.
If the card is a 4MD card, click the Provisioning > Optical Chn > Alarm Profiles >
Alarm Profile Editor tabs or the Provisioning > Optical Band > Alarm Profiles >
Alarm Profile Editor tabs.
If the card is an OPT-PRE or OPT-BST card, click the Provisioning > Optical Line >
Alarm Profiles > Alarm Profile Editor tabs or the Provisioning > Opt. Ampli. Line >
Alarm Profiles > Alarm Profile Editor tabs.
If the card is an AD-1C, AD-2C, or AD-4C card, click the Provisioning > Optical Line >
Alarm Profiles > Alarm Profile Editor tabs or the Provisioning > Optical Chn >
Alarm Profiles > Alarm Profile Editor tabs.
If the card is an AD-1B or AD-4B card, click the Provisioning > Optical Line > Alarm Profiles >
Alarm Profile Editor tabs or the Provisioning > Optical Band > Alarm Profiles >
Alarm Profile Editor tabs.
Click the node name you are logged into in the Node Names list.
Click the name of the profile in the Profile Names list, such as Default.
Chapter 7 Manage Alarms
November 2004