Table 10-13 Multiplexer And Demultiplexer Cards Optical Channel Threshold Settings; Dlp- G211 Change Optical Channel Threshold Settings For Multiplexer And Demultiplexer Cards - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 10 Change Card Settings
Table 10-12 Multiplexer and Demultiplexer Card Optical Channel Settings (continued)
Parameter Description
Actual Display only. Shows the wavelength specified by
Wavelength the manufacturing data. This field cannot be set
manually.
Expected Shows the preprovisioned wavelength. This field is
Wavelength used to preprovsion cards. For example, you can
specify a generic AD-1C in Slot 15 and set the
expected wavelength to 1552.52. The result is a
AD-1C-52.5. If the actual equipment installed does
not match the preprovisioned slot, a Mismatch
Equipment Alarm (MEA) occurs.
Step 4 Click Apply.
Return to your originating procedure (NTP).
Step 5
DLP-G211 Change Optical Channel Threshold Settings for Multiplexer and
Demultiplexer Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the multiplexer or demultiplexer cards where you want to change the optical
Step 1
threshold settings.
Click the Provisioning > Optical Chn > Optics Thresholds tabs.
Step 2
Modify any of the settings described in
Step 3

Table 10-13 Multiplexer and Demultiplexer Cards Optical Channel Threshold Settings

Parameter
Port
Power Low
(dBm)
Power High
(dBm)
September 2004
DLP-G211 Change Optical Channel Threshold Settings for Multiplexer and Demultiplexer Cards
This task changes the optical channel threshold settings for 32MUX-O,
32DMX-O, 32DMX, and 4MD-xx.x multiplexer and demultiplexer cards.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Table
Description
Display only. Displays the port number.
Set the low power settings.
Set the high power settings.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
Options
—
Numeric
10-13.
Options
—
Numeric. Can be set for 15-minute or
one-day intervals for Warning or Alarm.
Select the bullet and click Refresh.
Numeric. Can be set for 15-minute or
one-day intervals for Warning or Alarm.
Select the bullet and click Refresh.
10-21