Dlp-G49 Add A Node To The Current Session Or Login Group; Figure 2-2 Login Node Group - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G49 Add a Node to the Current Session or Login Group

Figure 2-2
192.168.106.143
Node 2
Return to your originating procedure (NTP).
Step 6
DLP-G49 Add a Node to the Current Session or Login Group
Purpose
Tools
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the CTC File menu, click Add Node.
Step 1
In the Add Node dialog box, enter the node name (or IP address).
Step 2
If you want to add the node to the current login group, check Add to current login node group.
Step 3
Otherwise, leave it unchecked.
Note
Click OK.
Step 4
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
2-30
Login Node Group
Laptop PC
IP Address
192.168.106.100
Node 1
IP Address
192.168.105.119
Three node ring
Node 3
This task adds a node to the current CTC session or login node group.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
This check box is active only if you selected a login group when you logged into CTC.
LAN/WAN (Ethernet)
Node 4
IP Address
192.168.104.109
Single
Chapter 2 Connect the PC and Log into the GUI
Node 5
IP Address
Two node ring
Node 6
IP Address
192.168.103.199
September 2004