Ntp-G25 Set Power Monitor Thresholds; Ntp-G26 Set Up Ctc Network Access - Cisco ONS 15454 DWDM Installation And Operation Manual

NTP-G25 Set Power Monitor Thresholds

NTP-G25 Set Power Monitor Thresholds
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
logged in, continue with Step 2.
In node view, click the Provisioning > General > Power Monitor tabs.
Step 2
To change the extreme low battery voltage threshold in 0.5 VDC increments, choose a voltage from the
Step 3
ELWBATVGVdc drop-down list.
To change the low battery voltage threshold in 0.5 VDC increments, choose a voltage from the
Step 4
LWBATVGVdc drop-down list.
To change the high battery voltage threshold in 0.5 VDC increments, choose a voltage from the
Step 5
HIBATVGVdc drop-down list.
Step 6 To change the extreme high battery voltage threshold in 0.5 VDC increments, choose a voltage from the
EHIBATVGVdc drop-down list.
Click Apply.
Step 7
Stop. You have completed this procedure.

NTP-G26 Set Up CTC Network Access

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
3-8
This procedure provisions extreme high, extreme low, and low input
battery power thresholds within a –48 volts direct current (VDC)
environment. When the thresholds are crossed, the TCC2 generates
warning alarms in CTC. For ONS 15454 power specifications, see
Appendix B, "Hardware Specifications."
None
NTP-G22 Verify Common Card Installation, page 3-2
Required
Onsite or remote
Provisioning or higher
"DLP-G46 Log into CTC" task on page 2-25
This procedure provisions network access for a node, including its subnet
mask, default router, Dynamic Host Configuration Protocol (DHCP)
server, IIOP (Internet Inter-Orb Protocol) listener port, proxy server
settings, static routes, Open Shortest Path First (OSPF) protocol, and
Routing Information Protocol (RIP).
None
NTP-G22 Verify Common Card Installation, page 3-2
Required
Onsite or remote
Superuser
Chapter 3
for the node you will set up. If you are already
Turn Up a Node
September 2004