Dlp-G146 View Optics Pm Parameters - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G146 View Optics PM Parameters

Step 3 Make an FEC selection based on the following rules:
•
•
•
Note
Click Apply.
Step 4
Click the Performance tab to view PM parameters. For PM parameter definitions, refer to the
Step 5
Cisco ONS 15454 SONET and DWDM Troubleshooting Guide.
Return to your originating procedure (NTP).
Step 6
DLP-G146 View Optics PM Parameters
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the transponder or muxponder card where you want to view PM counts. The
Step 1
card view appears.
Click the Performance > Optics PM tabs
Step 2
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
8-18
Choose Disable to disable the OTN FEC monitoring.
Choose Standard to enable standard FEC monitoring for that port (default).
Choose Enhanced to enable enhanced FEC monitoring for that port.
For TXP_MR_10E and MXP_MR_10E cards the FEC selection options available are Disable,
Standard, and Enhanced. For all the remaining transponder and muxponder cards the options
available are Enable and Disable.
This task enables you to view the optics PM counts on a transponder
(TXP_MR_10G, TXP_MR_2.5G, TXPP_MR_2.5G, TXP_MR_10E),
or a muxponder (MXP_2.5G_10E, MXP_MR_2.5G, MXPP_MR_2.5G,
MXP_2.5G_10G) card and port to detect possible performance
problems.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
(Figure 8-8).
Chapter 8 Monitor Performance
September 2004