Figure 8-15 Sonet Pm Tab On The Card View Performance Window - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 8 Monitor Performance
In node view, double-click the MXP_MR_2.5G or MXPP_MR_2.5G card where you want to view PM
Step 1
counts. The card view appears.
Click the Performance > Payload PM > SONET PM tabs
Step 2

Figure 8-15 SONET PM Tab on the Card View Performance Window

Card View
Performance tab
SONET tab
Payload PM tab
Direction
radio buttons
Interval
radio buttons
Click Refresh. Performance monitoring statistics appear for each port on the card.
Step 3
View the PM parameter names that appear in the Param column. The PM parameter values appear in the
Step 4
Prev-n columns. For PM parameter definitions, refer to the Cisco ONS 15454 SONET and DWDM
Troubleshooting Guide.
Note
Note
Return to your originating procedure (NTP).
Step 5
September 2004
Port Refresh
menu button
The MXP_MR_2.5G and MXPP_MR_2.5G cards support only OC48/STM16 payload. Each
payload has a set of PM parameters.
To refresh, reset, or clear PM counts, see the
page 8-2.
DLP-G152 View Payload SONET PM Parameters
(Figure
Auto-refresh Baseline
menu button
"NTP-G73 Change the PM Display" procedure on
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
8-15).
Clear Help
button button
8-27