Dlp-G249 Use The Reinitialization Tool To Clear The Database And Upload Software (Unix) - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G249 Use the Reinitialization Tool to Clear the Database and Upload Software (UNIX)

Step 13 If you are logged into CTC, close the browser window and disconnect the straight-through LAN cable
from the RJ-45 (LAN) port on the TCC2 card or on the hub or switch to which the ONS 15454 is
physically connected. Reconnect your straight-through LAN cable to the LAN port and log back into
CTC.
Step 14 Manually set the node name and network configuration to site-specific values. See the
Up Name, Date, Time, and Contact Information" procedure on page 3-6
Network Access" procedure on page 3-8
mask and gateway, and IIOP port.
Step 15 Return to your originating procedure (NTP).
DLP-G249 Use the Reinitialization Tool to Clear the Database and Upload
Software (UNIX)
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution Restoring a node to the factory configuration deletes all cross-connects on the node.
Restoring a node to factory configuration on a UNIX workstation should only be carried out on a standby
Caution
TCC2 card.
The TCC2 cards reboot several times during this procedure. Wait until they are completely rebooted
Note
before continuing.
JRE 1.4.2 must be installed on the computer you use to perform this procedure.
Note
Insert the system software CD containing the reinit tool, software, and defaults database into the
Step 1
computer CD-ROM drive. If the CTC Installation Wizard appears, click Cancel.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
11-8
for information on setting the node name, IP address, subnet
This task describes how to use the reinitialization (reinit) tool in a UNIX
environment. Use this tool to clear the database on the TCC2 card and
restore factory or customer defaults.
Software CD containing Software R3.4 or later, the node NE defaults,
and the reinit tool.
JRE 1.4.2 must be installed on the computer that you use to perform this
procedure.
NTP-G103 Back Up the Database, page 11-2
As needed to clear the existing database from a TCC2 card and restore
the node default settings.
Onsite or remote
Superuser
Chapter 11 Maintain the Node
"NTP-G24 Set
and "NTP-G26 Set Up CTC
September 2004