Ntp-G80 Change Node Management Information; Dlp-G160 Change The Node Name, Date, Time, And Contact Information - Cisco ONS 15454 DWDM Installation And Operation Manual

NTP-G80 Change Node Management Information

Step 5 Click the Port Status tab. Click Launch ANS.
ANS (Automatic Node Setup) automatically calculates the variable optical attenuator (VOAs) setpoints
to match the expected channel profile at the amplifier input port.
Stop. You have completed this procedure.
NTP-G80 Change Node Management Information
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
Step 2.
Step 2 Complete the
Step 3 In node view, click the Provisioning > General tabs.
Step 4 Complete the
page
Step 5 Complete the
Step 6 After confirming the changes, complete the
Stop. You have completed this procedure.

DLP-G160 Change the Node Name, Date, Time, and Contact Information

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution Changing the date, time, or time zone might invalidate the node's performance monitoring counters.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
9-8
This procedure changes the node name, date, time, contact information,
and the login legal disclaimer.
None
NTP-G24 Set Up Name, Date, Time, and Contact Information, page 3-6
As needed
Onsite or remote
Provisioning or higher
"DLP-G46 Log into CTC" task on page
"NTP-G103 Back Up the Database" procedure on page
"DLP-G160 Change the Node Name, Date, Time, and Contact Information" task on
9-8, as needed.
"DLP-G161 Change the Login Legal Disclaimer" task on page
This procedure changes basic information such as node name, date, time,
and contact information.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
2-25. If you are already logged in, continue with
"NTP-G103 Back Up the Database" procedure on page
Chapter 9 Manage the Node
11-2.
9-9, as needed.
September 2004
11-2.