Dlp-G210 Change Optical Channel Settings For Multiplexer And Demultiplexer Cards; Table 10-12 Multiplexer And Demultiplexer Card Optical Channel Settings - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 10 Change Card Settings
Step 4 Click Apply.
Return to your originating procedure (NTP).
Step 5
DLP-G210 Change Optical Channel Settings for Multiplexer and Demultiplexer
Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the multiplexer or demultiplexer card where you want to change the optical
Step 1
channel settings.
Click the Provisioning > Optical Chn > Parameters tabs.
Step 2
Modify any of the settings described in
Step 3

Table 10-12 Multiplexer and Demultiplexer Card Optical Channel Settings

Parameter Description
Port # Display only. Displays the port number.
Port Name Provides the ability to assign the specified port a
name.
Admin State Sets the port service state unless network
conditions prevent the change. For more
information about administrative states, see
Appendix C, "DWDM Enhanced State Model."
Line Direction Provides the ability to associate a card with the line
direction. Use this field if you have two cards in the
same shelf and must designate which one will carry
the traffic flow from east to west. The second card
will carry traffic from west to east.
Service State Identifies the autonomously generated state that
gives the overall condition of the port. Service
states appear in the format: Primary State-Primary
State Qualifier, Secondary State. For more
information about service states, see
"DWDM Enhanced State Model."
September 2004

DLP-G210 Change Optical Channel Settings for Multiplexer and Demultiplexer Cards

This task changes the optical channel settings for 32MUX-O, 32DMX-O,
32DMX, and 4MD-xx.x multiplexer and demultiplexer cards.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Table 10-12.
Options
Displays port number and TX or RX.
User-defined. Name can be up to 32 alphanumeric/
special characters. Blank by default.
See the
page 6-8.
• IS/Unlocked
IS,AINS/Unlocked,automaticInService
•
OOS,DSBLD/Locked,disabled
•
OOS,MT/Locked,maintenance
•
East to West
•
West to East
•
IS-NR/Unlocked-enabled
•
• OOS-AU,AINS/Unlocked-disabled,
automaticInService
OOS-MA,DSBLD/Locked-enabled,disabled
•
Appendix C,
OOS-MA,MT/Locked-enabled,maintenance
•
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
"DLP-G104 Assign a Name to a Port" task on
10-19