Ntp-G93 Modify Line Settings And Pm Parameter Thresholds For 32Wss Cards - Cisco ONS 15454 DWDM Installation And Operation Manual

NTP-G93 Modify Line Settings and PM Parameter Thresholds for 32WSS Cards

Step 4 Click Apply.
Return to your originating procedure (NTP).
Step 5
NTP-G93 Modify Line Settings and PM Parameter Thresholds for
32WSS Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
32WSS card settings. If you are already logged in, proceed to
Complete the
Step 2
Perform any of the following tasks as needed:
Step 3
•
•
•
•
Complete the
Step 4
Stop. You have completed this procedure.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
10-22
This procedure changes the line and threshold settings for the 32WSS card.
None
NTP-G30 Install the DWDM Cards, page 3-26
As needed
Onsite or remote
Provisioning or higher
"DLP-G46 Log into CTC" task on page 2-25
"NTP-G103 Back Up the Database" procedure on page
DLP-G212 Change Optical Channel Parameters for the 32WSS Card, page 10-23
DLP-G213 Change Optical Channel Optics Thresholds for the 32WSS Card, page 10-25
Note To use the alarm profile tab, including creating alarm profiles and suppressing alarms, see
Chapter 7, "Manage Alarms."
DLP-G214 Change Optical Line Parameters for the 32WSS Card, page 10-26
DLP-G215 Change Optical Line Optics Thresholds for the 32WSS Card, page 10-28
"NTP-G103 Back Up the Database" procedure on page
Chapter 10 Change Card Settings
at the node where you want to change the
Step 2.
11-2.
11-2.
September 2004