Cisco ONS 15454 DWDM Installation And Operation Manual page 64

Required Tools and Equipment (ANSI)
9.
10.
11.
12.
13.
14.
15.
16.
This equipment must be installed and maintained by service personnel as defined by AS/NZS 3260.
Warning
Incorrectly connecting this equipment to a general-purpose outlet could be hazardous. The
telecommunications lines must be disconnected 1) before unplugging the main power connector or
2) while the housing is open, or both.
This unit is intended for installation in restricted access areas. A restricted access area can be
Warning
accessed only through the use of a special tool, lock and key, or other means of security.
Warning Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning A readily accessible two-poled disconnect device must be incorporated in the fixed wiring.
The ONS 15454 is suitable for mounting on concrete or other noncombustible surfaces only.
Note
In this chapter, "shelf assembly" refers to the steel enclosure that holds cards and connects power, and
Note
"node" refers to the entire hardware and software system.
Required Tools and Equipment (ANSI)
You need the following tools and equipment to install and test the ONS 15454 ANSI shelf assembly.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
1-2
NTP-G9 Install the Alarm Expansion Panel (ANSI Only), page
you are planning to install the Alarm Interface Controller–International (AIC-I) card and want to
increase the number of alarm contacts provided by the AIC-I card.
NTP-G10 Attach Wires to Alarm, Timing, LAN, and Craft Pin Connections, page
as needed to set up wire-wrap pin connections.
NTP-G11 Install an External Wire-Wrap Panel on the AEP (ANSI Only), page 1-59
procedure to connect an external wire-wrap panel to the alarm expansion panel (AEP).
NTP-G12 Install and Close the FMEC Cover (ETSI Only), page
install the FMEC cover.
NTP-G13 Install the Rear Cover (ANSI Only), page
install the rear cover after you have finished servicing the backplane.
NTP-G14 Install DWDM Equipment, page
equipment needed for DWDM networks.
NTP-G15 Install the Common Control Cards, page
TCC2 card and the Alarm Interface Controller (AIC) or AIC-I card.
NTP-G16 Perform the Shelf Installation Acceptance Test, page
determine if you have correctly completed all other procedures in the chapter.
Chapter 1 Install the Shelf and Common Control Cards
1-44—Complete this procedure if
1-63—Complete this procedure to
1-65—Complete this procedure as needed to
1-66—Complete this procedure as needed to install
1-72—Complete this procedure to install the
1-77—Complete this procedure to
1-47—Complete
—Complete this
September 2004