Dlp-G105 Provision Dwdm Optical Channel Network Connections; Table 6-3 Ochnc Channels - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 6 Create Channels and Circuits
Step 2 Click the Provisioning tab.
Click the Port Name column for the port number to which you are assigning a name.
Step 3
Type the port name.
Step 4
The port name can be up to 32 alphanumeric/special characters. The field is blank by default.
Click Apply.
Step 5
Return to your originating procedure (NTP).
Step 6

DLP-G105 Provision DWDM Optical Channel Network Connections

Purpose
Tools/Equipment
Prerequisite Procedures All procedures in
Required/As Needed
Onsite/Remote
Security Level
Choose View > Go to Network View.
Step 1
Step 2 Click the Circuits tab, then click Create.
Step 3 In the Circuit Creation dialog box, choose OCHNC from the Circuit Type list.
Step 4 Click Next.
Define the circuit attributes:
Step 5
•
•
•
Table 6-3
Channel No. Channel ID
1
2
3
4
5
September 2004
This procedure creates an OCHNC between ONS 15454s that are
provisioned for DWDM.
An OCHNC add port on the source node and an OCHNC drop port on
destination node of the same wavelength are required.
DLP-G46 Log into CTC, page 2-25
nodes within the OCHNC route.
As needed
Onsite
Provisioning or higher
Name—Assign a name to the OCHNC. The name can be alphanumeric and up to 48 characters
(including spaces). Circuit names should be 44 characters or less if you want the ability to create
monitor circuits. If you leave the field blank, CTC assigns a default name to the circuit.
Size—Equipped non specific is the default. You cannot change it.
OCHNC Channel—Choose the wavelength you want to provision.
available wavelengths.
OCHNC Channels
30.3
31.2
31.9
32.6
34.2
DLP-G105 Provision DWDM Optical Channel Network Connections
Chapter 3, "Turn Up a Node"
Frequency (GHz) Wavelength (nm)
195.9 1530.33
195.8 1531.12
195.7 1531.90
195.6 1532.68
195.4 1534.25
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
must be completed at all
Table 6-3 lists the thirty-two
6-9