Ntp-G61 Modify And Delete Overhead Circuits; Dlp-G111 Repair An Ip Tunnel - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 6 Create Channels and Circuits

NTP-G61 Modify and Delete Overhead Circuits

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Deleting circuits can be service affecting and should be performed during a maintenance window.
Caution
Complete the
Step 1
to repair or delete a circuit. If you are already logged in, continue with Step 2.
As needed, complete the
Step 2
As needed, complete the
Step 3
Stop. You have completed this procedure.

DLP-G111 Repair an IP Tunnel

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Obtain the original IP address of the node in question.
Step 1
From the View menu, choose Go to Network View.
Step 2
From the Tools menu, choose Overhead Circuits > Repair IP Circuits.
Step 3
Step 4 Review the text in the IP Repair wizard and click Next.
Step 5 In the Node IP address area, complete the following:
•
•
Click Next.
Step 6
Click Finish.
Step 7
September 2004
This procedure repairs IP circuits and deletes overhead circuits.
None
NTP-G60 Create Overhead Circuits, page 6-12
As needed
Onsite or remote
Provisioning or higher
"DLP-G46 Log into CTC" task on page 2-25
"DLP-G111 Repair an IP Tunnel" task on page
"DLP-G112 Delete Overhead Circuits" task on page
This task repairs circuits that have a OOS-PARTIAL status as a result of
node IP address changes.
None
DLP-G107 Create an IP-Encapsulated Tunnel, page 6-13
As needed
Onsite or remote
Provisioning or higher
Node—Choose the node that has an OOS-PARTIAL circuit.
Old IP Address—Type the node's original IP address.
NTP-G61 Modify and Delete Overhead Circuits
for a node on the network where you want
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
6-17.
6-18.
6-17