Cisco ONS 15454 DWDM Installation And Operation Manual page 611

Chapter 13 Shelf Hardware Reference
13.13 ONS 15454 ANSI Alarm, Timing, LAN, and Craft Pin Connections
Always use the supplied ESD wristband when working with a powered ONS 15454. Plug the wristband
Caution
cable into the ESD jack located on the lower-right outside edge of the shelf assembly.
The ONS 15454 ANSI has a backplane pin field located at the bottom of the backplane. The backplane
2 2
pin field provides 0.045 inch (29 mm ) wire-wrap pins for enabling external alarms, timing input and
output, and craft interface terminals. This section describes the backplane pin field and the pin
assignments for the field. Figure 13-41 shows the wire-wrap pins on the backplane pin field. Beneath
each wire-wrap pin is a frame ground pin. Frame ground pins are labeled FG1, FG2, FG3, etc. Install the
ground shield of the cables connected to the backplane to the ground pin that corresponds to the pin field
used.
The AIC-I requires a shelf assembly running Software Release 3.4.0 or later. The backplane of the ANSI
Note
shelf contains a wire-wrap field with pin assignment according to the layout in Figure 13-41. The shelf
assembly might be an existing shelf that has been upgraded to R3.4 or later. In this case the backplane
pin labeling appears as indicated in Figure 13-42 on page 13-47, but you must use the pin assignments
provided by the AIC-I as shown in Figure 13-41.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
13-45
September 2004