Dlp-G14 Remove The Backplane Sheet Metal Cover; Ntp-G6 Install The Mic-A/P And Mic-T/C/P Fmecs (Etsi Only) - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 1 Install the Shelf and Common Control Cards

DLP-G14 Remove the Backplane Sheet Metal Cover

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
To remove the lower clear plastic backplane cover, loosen the five screws that secure it to the ONS 15454
Step 1
and pull it away from the shelf assembly.
Loosen the nine perimeter screws that hold the backplane sheet metal cover(s) in place.
Step 2
Lift the panel by the bottom to remove it from the shelf assembly.
Step 3
Store the panel for later use. Attach the backplane cover(s) whenever electrical interface assemblies
Step 4
(EIA[s]) are not installed.
Return to your originating procedure (NTP).
Step 5

NTP-G6 Install the MIC-A/P and MIC-T/C/P FMECs (ETSI Only)

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution Always use the supplied ESD wristband when working with a powered ONS 15454 ETSI. Plug the
wristband cable into the ESD jack located on the lower-right outside edge of the shelf assembly.
September 2004
This task removes the backplane sheet metal cover that is installed on the
backplane.
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
DLP-G13 Remove the Lower Backplane Cover, page 1-26
Required
Onsite
None
This procedure installs the MIC-A/P and the MIC-T/C/P, which are a type
of FMEC installed in the EFCA. The EFCA is located at the top of the
ONS 15454 ETSI shelf. It provides connection for installing power,
external alarms, timing input and output, and craft interface terminals.This
procedure applies to the ETSI shelf only.
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
FMEC cards (the MIC-A/P and MIC-T/C/P)
NTP-G4 Open and Remove the FMEC Cover (ETSI Only), page 1-23
Required
Onsite
None
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
DLP- G14 Remove the Backplane Sheet Metal Cover
1-27