Ntp-G23 Create Users And Assign Security - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 3 Turn Up a Node
Note
If your site plan requires an AIC or AIC-I card, verify that the AIC/AIC-I card is installed in Slot 9 and
Step 3
its ACT (active) LED displays a solid green light.
Verify that the software release shown on the LCD matches the software release indicated in your site
Step 4
plan. If the release does not match, perform one of the following procedures:
•
•
Stop. You have completed this procedure.

NTP-G23 Create Users and Assign Security

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
If you are already logged in, continue with Step 2.
Note
Complete the
Step 2
a New User—Multiple Nodes" task on page 3-4
Note
If you want to modify the security policy settings, including password aging and idle user timeout
Step 3
policies, complete the
Stop. You have completed this procedure.
September 2004
If the TCC2 cards are not installed, or if their LEDs are not operating as described, do not
continue. Repeat the "DLP-G33 Install the TCC2 Card" task on page 1-73
ONS 15454 SONET and DWDM Troubleshooting Guide to resolve installation problems before
proceeding to Step 3.
Perform a software upgrade using a Cisco ONS 15454 software CD. Refer to the release-specific
software upgrade document.
Replace the TCC2 cards with cards containing the correct release.
This procedure creates ONS 15454 users and assigns their security levels.
None
NTP-G22 Verify Common Card Installation, page 3-2
As needed
Onsite or remote
Superuser only
"DLP-G46 Log into CTC" task on page 2-25
You must log in as a Superuser to create additional users. The CISCO15 user provided with each
ONS 15454 can be used to set up other ONS 15454 users. You can add up to 500 users to one
ONS 15454.
"DLP-G54 Create a New User—Single Node" task on page 3-4
You must add the same user name and password to each node a user will access.
"NTP-G88 Modify Users and Change Security" procedure on page
at the node where you need to create users.
as needed.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
NTP-G23 Create Users and Assign Security
or refer to the Cisco
or the "DLP-G55 Create
9-34.
3-3