Ntp-G115 Clean Fiber Connectors - Cisco ONS 15454 DWDM Installation And Operation Manual

NTP-G115 Clean Fiber Connectors

NTP-G115 Clean Fiber Connectors
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Invisible laser radiation may be emitted from the end of the unterminated fiber cable or connector. Do
Warning
not stare into the beam or view directly with optical instruments.
Using an inspection microscope, inspect each fiber connector for dirt, cracks, or scratches.
Step 1
Replace any damaged fiber connectors.
Step 2
Note
Complete the
Step 3
Wipes" task on page 11-33
Complete the
Step 4
Complete the
Step 5
Do not reuse optical swabs. Keep unused swabs off of work surfaces.
Caution
Stop. You have completed this procedure.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
11-32
This procedure cleans the fiber connectors.
Inspection microscope
Compressed air/duster
Type A Fiber Optic Connector Cleaner (CLETOP reel)
Isopropyl alcohol 70 percent or higher
Optical swab
Optical receiver cleaning stick
None
Required
Onsite
None
Replace all dust caps whenever the equipment is unused for 30 minutes or more.
"DLP-G261 Scope and Clean Fiber Connectors and Adapters with Alcohol and Dry
as necessary.
"DLP-G262 Clean Fiber Connectors with CLETOP" task on page 11-34
"DLP-G263 Clean the Fiber Adapters" task on page 11-34
Chapter 11 Maintain the Node
as necessary.
as necessary.
September 2004