Dlp-G256 Place 4Md-Xx.x Ports Out Of Service - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 11 Maintain the Node
Step 4 Click Apply.
In the confirmation dialog box, click Yes.
Step 5
If the card is a 32WSS, repeat Steps
Step 6
Click the Provisioning > Optical Line > Parameters tabs.
Step 7
Under Admin State, choose OOS,DSLB for each port that does not have an OOS-MA,DSLB service
Step 8
state.
Click Apply.
Step 9
In the confirmation dialog box, click Yes.
Step 10
Return to your originating procedure (NTP).
Step 11

DLP-G256 Place 4MD-xx.x Ports Out of Service

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
On the shelf graphic in CTC, double-click the 4MD card with the ports you want to put out of service.
Step 1
Click the Provisioning > Optical Chn > Parameters tabs.
Step 2
Under Admin State, choose OOS,DSLB for each port that does not have an OOS-MA,DSLB service
Step 3
state.
Click Apply.
Step 4
In the confirmation dialog box, click Yes.
Step 5
Click the Provisioning > Optical Band > Parameters tabs.
Step 6
Under Admin State, choose OOS,DSLB for each port that does not have an OOS-MA,DSLB service
Step 7
state.
Click Apply.
Step 8
In the confirmation dialog box, click Yes.
Step 9
Return to your originating procedure (NTP).
Step 10
September 2004
3 through 5 for the Optical Chn Optical Connector [2...4] tabs.
This task places 4MD-xx.x card ports out of service in preparation for
card removal.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
DLP-G256 Place 4MD-xx.x Ports Out of Service
11-17