Ntp-G51 Verify Dwdm Node Turn Up - Cisco ONS 15454 DWDM Installation And Operation Manual

NTP-G51 Verify DWDM Node Turn Up

NTP-G51 Verify DWDM Node Turn Up
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Log into an ONS 15454 on the network that you will test. See the
Step 1
page
Click the Alarms tab.
Step 2
a.
b.
Step 3 Verify that the software version and defaults shown in the node view status area match the software
version and NE defaults shown in your site plan. If either is not correct, complete the following
procedures as needed:
•
•
Click the Provisioning > General tabs. Verify that all general node information settings match the
Step 4
settings of your site plan. If not, see the
on page
Click the Provisioning > Network tabs. Ensure that the IP settings and other Cisco Transport Controller
Step 5
(CTC) network access information is correct. If not, see the
procedure on page
Step 6 Click the Provisioning > Protection tabs. Verify that all protection groups have been created according
to your site plan. If not, see the
page
Click the Provisioning > Security tabs. Verify that all users have been created and that their security
Step 7
levels match the settings indicated by your site plan. If not, see the
Security" procedure on page
If Simple Network Management Protocol (SNMP) is provisioned on the node, click the Provisioning >
Step 8
SNMP tabs. Verify that all SNMP settings match the settings of your site plan. If not, see the
Change SNMP Settings" procedure on page
Step 9 Provision the network connections using the
on page
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
5-2
This procedure verifies that each ONS 15454 is ready for DWDM network
turn up before adding nodes to a network.
None
Chapter 3, "Turn Up a Node"
Required
Onsite
Provisioning or higher
2-25. If you are already logged in, proceed to Step 2.
Verify that the alarm filter is not turned on. See the
page 7-32 as necessary.
Verify that no unexplained alarms appear. If alarms appear, investigate and resolve them before
continuing. Refer to the Cisco ONS 15454 SONET and DWDM Troubleshooting Guide for
procedures.
If the software is not the correct version, install the correct version from the ONS 15454 software
CD. Upgrade procedures are located in the release-specific software upgrade document. Follow the
upgrade procedures appropriate to the software currently installed on the node. TCC2 cards can also
be ordered with the latest software release.
If the node defaults are not correct, import the network element defaults. Refer to the
Cisco ONS 15454 Network Element Defaults publication for Software R4.7.
9-8.
9-10.
9-20.
9-34.
5-3.
"DLP-G128 Disable Alarm Filtering" task on
"NTP-G80 Change Node Management Information" procedure
"NTP-G83 Modify or Delete Card Protection Settings" procedure on
9-42.
"NTP-G52 Verify Node-to-Node Connections" procedure
Chapter 5
"DLP-G46 Log into CTC" task on
"NTP-G81 Change CTC Network Access"
"NTP-G88 Modify Users and Change
Turn Up Network
"NTP-G89
November 2004