Dlp-G145 Enable/Disable Otn Fec Performance Monitoring - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 8 Monitor Performance
Step 5 Click the Performance tab to view PM parameters. For PM parameter definitions, refer to the
Cisco ONS 15454 SONET and DWDM Troubleshooting Guide.
Return to your originating procedure (NTP).
Step 6

DLP-G145 Enable/Disable OTN FEC Performance Monitoring

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the card you want to monitor. The card view appears.
Step 1
Click the Provisioning > OTN > OTN Lines tabs
Step 2
Figure 8-7
Provisioning
OTN Lines tab
September 2004
OTN Lines Tab for Enabling/Disabling OTN FEC Performance Monitoring for TXP_MR_10E
Cards
Card View
tab
OTN tab
DLP-G145 Enable/Disable OTN FEC Performance Monitoring
This task enables or disables OTN FEC monitoring of node near-end or
far-end performance on a selected card and port during selected time
intervals.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
(Figure
FEC
check box
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
8-7).
Apply
button
8-17