Mic-A/P Connector Pinouts; Figure 14-6 Mic-A/P Faceplate And Block Diagram; Table 14-15 Alarm Interface Pinouts On The Mic-A/P Db-62 Connector - Cisco ONS 15454 DWDM Installation And Operation Manual

14.3.1 MIC-A/P FMEC

Figure 14-6 MIC-A/P Faceplate and Block Diagram

MIC-A/P
ALARM
IN/OUT
BATTERY B
The MIC-A/P FMEC has the following features:
•
•
•
•
•
For proper system operation, both the MIC-A/P and MIC-C/T/P FMECs must be installed in the
Note
ONS 15454 ETSI shelf.

14.3.1.1 MIC-A/P Connector Pinouts

Table 14-15

Table 14-15 Alarm Interface Pinouts on the MIC-A/P DB-62 Connector

Pin No.
1
2
3
4
5
6
7
8
9
10
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
14-22
+
Connection for one of the two possible redundant power supply inputs
Connection for eight alarm outputs (coming from the TCC2 card)
Connection for four configurable alarm inputs/outputs
Connection for sixteen alarm inputs
Storage of manufacturing and inventory data
shows the alarm interface pinouts on the MIC-A/P DB-62 connector.
Signal Name
ALMCUTOFF N
ALMCUTOFF P
ALMINP0 N
ALMINP0 P
ALMINP1 N
ALMINP1 P
ALMINP2 N
ALMINP2 P
ALMINP3 N
ALMINP3 P
Power
3W3
Connector
16 Alarm inputs
4 Alarm in/outputs
Alarms
DB62
Connector
Signal Description
Alarm cutoff, normally open ACO pair
Alarm cutoff, normally open ACO pair
Alarm input pair 1, reports closure on connected wires
Alarm input pair 1, reports closure on connected wires
Alarm input pair 2, reports closure on connected wires
Alarm input pair 2, reports closure on connected wires
Alarm input pair 3, reports closure on connected wires
Alarm input pair 3, reports closure on connected wires
Alarm input pair 4, reports closure on connected wires
Alarm input pair 4, reports closure on connected wires
Chapter 14 Card Reference
B
a
c
k
p
l
a
n
Inventory Data
e
(EEPROM)
December 2004