Dlp-G148 View Otn Pm Parameters; Figure 8-10 Viewing Otn Itu-T G.709 Performance Monitoring Information - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 8 Monitor Performance

DLP-G148 View OTN PM Parameters

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the transponder or muxponder card where you want to view PM counts. The
Step 1
card view appears.
Click the Performance > OTN PM > G.709 tabs
Step 2

Figure 8-10 Viewing OTN ITU-T G.709 Performance Monitoring Information

Performance
OTN PM tab
radio buttons
radio buttons
View the PM parameter names that appear in the Param column. The PM parameter values appear in the
Step 3
Curr (current) and Prev-n (previous) columns. For PM parameter definitions, refer to the
Cisco ONS 15454 SONET and DWDM Troubleshooting Guide.
Click the FEC PM tab
Step 4
September 2004
Card View
tab
G.709 PM
tab
Directions
Intervals
(Figure
This task enables you to view the OTN PM counts on a transponder
(TXP_MR_10G, TXP_MR_2.5G, TXPP_MR_2.5G, TXP_MR_10E),
or muxponder (MXP_2.5G_10E, MXP_2.5G_10G) card and port to
detect possible performance problems.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
(Figure
Signal-type Refresh
port menu button
8-11).
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
DLP-G148 View OTN PM Parameters
8-10).
Auto-refresh Baseline
menu button
Clear Help
button button
8-21