Dlp-G42 Set Up A Solaris Workstation For A Craft Connection To An Ons 15454 - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G42 Set Up a Solaris Workstation for a Craft Connection to an ONS 15454

b.
c.
d.
e.
f.
g.
h.
i.
Return to your originating procedure (NTP).
Step 7
DLP-G42 Set Up a Solaris Workstation for a Craft Connection to an ONS 15454
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Log into the workstation as the root user.
Check to see if the interface is plumbed by typing:
Step 2
# ifconfig device
For example:
# ifconfig hme1
If the interface is plumbed, a message similar to the following appears:
hme1:flags=1000842<BROADCAST,RUNNING,MULTICAST,IPv4>mtu 1500 index 2 inet 0.0.0.0
netmask 0
If a message similar to this one appears, go to
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
2-18
If the Network Connections menu is not available, click Switch to Classic View.
Note
From the Network Connections dialog box, click the Local Area Connection icon.
From the Local Area Connection Properties dialog box, choose Internet Protocol (TCP/IP), then
click Properties.
In the IP Address field, enter any legitimate IP address other than the node IP address as indicated
on the LCD of the ONS 15454. The default IP address is 192.1.0.2.
You can suppress the LCD IP address display using CTC. For more information, see the
Note
"DLP-G162 Change IP Settings" task on page
In the Subnet Mask field, type the same subnet mask as the ONS 15454. The default is
255.255.255.0 (24 bit).
Type the IP address entered in Step
Click OK.
In the Local Area Connection Properties dialog box, click OK.
In the Local Area Connection Status dialog box, click Close.
This task sets up a Solaris workstation for a craft connection to the
ONS 15454.
None
NTP-G17 Set Up Computer for CTC, page 2-2
As needed
Onsite
None
Chapter 2
9-11.
d in the Gateway Address field.
Step 4.
Connect the PC and Log into the GUI
September 2004