Cisco ONS 15454 DWDM Installation And Operation Manual page 459

Chapter 10 Change Card Settings
Table 10-16 32WSS Optical Line Parameter Settings (continued)
Parameter Description
Admin State Sets the port service state unless network conditions
prevent the change. For more information about
administrative states, see
Enhanced State Model."
Service State Identifies the autonomously generated state that
gives the overall condition of the port. Service states
appear in the format: Primary State-Primary State
Qualifier, Secondary State. For more information
about service states, see
Enhanced State Model."
Line Display only. Displays the direction that the optical
Direction signal flows.
Type Port type.
Power Power value read by the photodiode associated with
the port.
AINS Soak Sets the automatic in-service soak period.
Return to your originating procedure (NTP).
Step 4
September 2004
Appendix C, "DWDM
Appendix C, "DWDM
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
DLP-G214 Change Optical Line Parameters for the 32WSS Card
Options
• IS/Unlocked
• IS,AINS/Unlocked,automaticInService
OOS,DSBLD/Locked,disabled
•
OOS,MT/Locked,maintenance
•
IS-NR/Unlocked-enabled
•
OOS-AU,AINS/Unlocked-disabled,
•
automaticInService
OOS-MA,DSBLD/Locked-enabled,disabled
•
OOS-MA,MT/Locked-enabled,maintenance
•
West to East (the direction in which channels are
•
added)
• East to West (the direction in which channels are
dropped)
Output Express
•
Input Express
•
Out Com
•
• Input Com
Drop
•
• Numeric value (dB)
Duration of valid input signal, in hh.mm format,
•
after which the card becomes in service (IS)
automatically
• 0 to 48 hours, 15-minute increments
10-27