Dlp-G222 Change Card Settings For Mxp_2.5G_10G And Mxp 2.5G_10E Cards; Table 10-28 Mxp_2.5G_10G Or Mxp_2.5G_10E Muxponder Card Settings - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G222 Change Card Settings for MXP_2.5G_10G and MXP 2.5G_10E Cards

DLP-G222 Change Card Settings for MXP_2.5G_10G and MXP 2.5G_10E Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 In node view, double-click the MXP_2.5G_10G or and MXP_2.5G_10E card where you want to change
the card settings.
Step 2 Click the Provisioning > Card tabs.
Step 3 Modify any of the settings described in

Table 10-28 MXP_2.5G_10G or MXP_2.5G_10E Muxponder Card Settings

Parameter
Termination
Mode
Wavelength
Card
Parameters
Click Apply.
Step 4
Return to your originating procedure (NTP).
Step 5
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
10-44
This task changes the card settings for MXP_2.5G_10G or
MXP_2.5G_10E muxponder cards, including payload type, termination
mode, and wavelength.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Table
Description
Sets the mode of operation. Options that
do not apply to a card do not display. See
"14.12 Transponder and Muxponder
Termination Modes" section on
page 14-122 for more information.
Sets the wavelength of the DWDM trunk
side of the optical transmitter.
Displays the settings for the card.
10-28.
Options
Transparent
•
Section
•
Line
•
First Tunable Wavelength
•
Further wavelengths in 100-GHz ITU
•
grid specification
Supported wavelengths are in white
•
and marked by asterisks (**);
unsupported wavelengths are gray
Information only.
Chapter 10 Change Card Settings
September 2004