Chapter 10
Change Card Settings
Step 2
Click the Provisioning > Line > Section Trace tab. Tabs and parameter selections vary according to
PPM provisioning.
Modify any of the settings in the Section Trace tab as described in
Step 3
Table 10-52 MXP_MR_2.5G and MXPP_MR_2.5G Muxponder Card Line Section Trace Tab Settings
Parameter
Port
Trace Mode
Section Trace
String Size
Transmit
Expected
Received
Click Apply.
Step 4
Step 5
Return to your originating procedure (NTP).
DLP-G240 Change Line Threshold Settings for MXP_MR_2.5G
and MXPP_MR_2.5G Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the MXP_MR_2.5G or MXPP_MR_2.5G card where you want to change the
Step 1
line threshold settings.
Click the Provisioning > Line Thresholds tabs.
Step 2
Modify any of the settings as shown in
Step 3
September 2004
DLP-G240 Change Line Threshold Settings for MXP_MR_2.5G and MXPP_MR_2.5G Cards
Description
Sets the port number.
Sets the trace mode.
Sets the trace string size.
Displays the current transmit string;
sets a new transmit string.
Displays the current expected string;
sets a new expected string.
Display only. Displays the current
received string.
This task changes the line threshold settings for MXP_MR_2.5G and
MXPP_MR_2.5G muxponder cards.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Table
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
Table
Options
•
9 (trunk for MXP_MR_2.5G) or 9
and 10 (trunk for MXPP_MR_2.5G)
Off/None
•
Auto
•
Manual
•
1 byte
•
16 byte
•
String of trace string size
String of trace string size
String of trace string size
10-53.
10-52.
10-73