Figure 7-3 Ctc Node View; Table 7-1 Alarm Column Descriptions - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 7 Manage Alarms
Figure 7-3
Table 7-1
Table 7-1
Column
Num
Ref
New
Date
Object
Eqpt Type
Slot
Port
Path Width
Sev
ST
SA
November 2004
CTC Node View
describes the columns in the Alarms window.
Alarm Column Descriptions
Information Recorded
Sequence number of the original alarm
Reference number of the original alarm
Indicates a new alarm; to change this status, click either the Synchronize button or
the Delete Cleared Alarms button.
Date and time of the alarm.
TL1 access identifier (AID) for the alarmed object; for an STSmon or VTmon, this is
the monitored STS or VT.
If an alarm is raised on a card, the card type in this slot.
If an alarm is raised on a card, the slot where the alarm occurred (appears only in
network and node view).
If an alarm is raised on a card, the port where the alarm is raised; for STSTerm and
VTTerm, the port refers to the upstream card it is partnered with.
Indicates how many STSs are contained in the alarmed path. This information
complements the alarm object notation, which is explained in the
Cisco ONS 15454 SONET and DWDM Troubleshooting Guide.
Severity level: CR (Critical), MJ (Major), MN (minor), NA (Not Alarmed), NR
(Not Reported).
Status: R (raised), C (clear).
When checked, indicates a service-affecting alarm.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
DLP-G115 View Alarms
7-7