Dlp-G180 Clear A Manual Or Force Y-Cable Or Splitter Protection Switch - Cisco ONS 15454 DWDM Installation And Operation Manual

Hide thumbs Also See for ONS 15454 DWDM:
Table of Contents

Advertisement

Chapter 9
Manage the Node
Step 3
In the Selected Group area, click the active card or port.
From Switch Commands, click Force.
Step 4
In the Confirm Manual Operation dialog box, click Yes.
Step 5
The Manual switch will be applied. To clear the Force switch, see the
Force Y-Cable or Splitter Protection Switch" task on page
Return to your originating procedure (NTP).
Step 6

DLP-G180 Clear a Manual or Force Y-Cable or Splitter Protection Switch

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Maintenance > Protection tabs.
Step 1
In the Protection Groups area, click the protection group that contains the card you want to clear.
Step 2
In the Selected Group area, click the card you want to clear.
Step 3
From Switch Commands, click Clear.
Step 4
Step 5
Click Yes in the confirmation dialog box.
The Manual or Force protection switch is cleared.
Step 6
Return to your originating procedure (NTP).
September 2004
DLP-G180 Clear a Manual or Force Y-Cable or Splitter Protection Switch
This task clears a Manual or Force protection switch on a Y-Cable or
splitter protection group.
None
DLP-G46 Log into CTC, page 2-25
DLP-G178 Apply a Manual Y-Cable or Splitter Protection Switch, page
9-24
or
DLP-G179 Apply a Force Y-Cable or Splitter Protection Switch, page
9-24
As needed
Both
Maintenance or higher
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
"DLP-G180 Clear a Manual or
9-25.
9-25

Advertisement

Table of Contents
loading

Table of Contents