Dlp-G260 Clear A Manual Or Force Switch On A Node Timing Reference; Ntp-G113 View The Ons 15454 Timing Report - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 11 Maintain the Node
Step 5 Click Yes in the confirmation dialog box. If the selected timing reference is an acceptable valid
reference, the node switches to the selected timing reference. If the selected timing reference is invalid,
a warning dialog box appears. Click OK; the node will not switch to the new timing reference.
Return to your originating procedure (NTP).
Step 6

DLP-G260 Clear a Manual or Force Switch on a Node Timing Reference

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Maintenance > Timing > Source tabs.
Step 1
Find the Clock reference that is currently set to Manual or Force in the Operation menu.
Step 2
From the Operation drop-down list, choose Clear.
Step 3
Click Apply.
Step 4
Click Yes in the confirmation dialog box. If the normal timing reference is an acceptable valid reference,
Step 5
the node switches back to the normal timing reference as defined by the system configuration. If the
normal timing reference is invalid or has failed, a warning dialog box appears. Click OK; the timing
reference will not revert.
Return to your originating procedure (NTP).
Step 6

NTP-G113 View the ONS 15454 Timing Report

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
timing status. If you are already logged in, continue with
Click the Maintenance > Timing > Report tabs.
Step 2
September 2004
This task clears a Manual or Force switch on a node timing reference and
reverts the timing reference to its provisioned reference.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Maintenance or higher
This procedure displays the current status of the ONS 15454 timing
references.
None
NTP-G53 Set Up Timing, page 5-4
As needed
Onsite or remote
Maintenance or higher
"DLP-G46 Log into CTC" task on page 2-25
DLP-G260 Clear a Manual or Force Switch on a Node Timing Reference
at the node where you want to view the node
Step 2.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
11-25