Mxp_Mr_2.5G And Mxpp_Mr_2.5G Safety Labels; Figure 14-64 Laser Radiation Warning-Hazard Level Label; Figure 14-65 Laser Radiation Warning-Laser Source Connector Label - Cisco ONS 15454 DWDM Installation And Operation Manual

Hide thumbs Also See for ONS 15454 DWDM:
Table of Contents

Advertisement

Chapter 14
Card Reference
The MXPP_MR_2.5G card features a 1550-nm laser for the trunk/line port and a 1310-nm or 850-nm
laser (depending on the SFP) for the client port. The card contains eight 12.5 degree downward tilt SFP
modules for the client interfaces. For optical termination, each SFP uses two LC connectors, which are
labeled TX and RX on the faceplate. There are two trunk port connectors (one for working and one for
protect). Each is a dual LC connector with a 45 degree downward angle.
The MXP_MR_2.5G and MXPP_MR_2.5G cards detect SF, LOS, or LOF conditions on the trunk
interface of the optical facility. Refer to the Cisco ONS 15454 Troubleshooting Guide for a description
of these conditions. The card also counts section and line BIP errors for the trunk interface from the B1
and B2 byte registers in the section and line overhead.

14.8.6.3 MXP_MR_2.5G and MXPP_MR_2.5G Safety Labels

The MXP_MR_2.5G and MXPP_MR_2.5G cards have several safety labels that provide laser radiation
and electrical shock warnings.
Figure 14-64
clearly labeled with warnings about the equipment radiation level. Personnel must understand all
warning labels before working with these cards. The hazard level label warns the personnel against
exposure to laser radiation of Class 1 limits calculated in accordance with IEC60825-1 Ed.1.2.
Figure 14-64 Laser Radiation Warning—Hazard Level Label
Figure 14-65
connectors where it has been placed.
Figure 14-65 Laser Radiation Warning—Laser Source Connector Label
Figure 14-66
standards and that the hazard level classification is in accordance with IEC60825-1 Am.2 or Ed.1.2.
December 2004
shows the laser radiation warning hazard level label. The faceplate of these cards are
HAZARD
LEVEL 1M
shows the laser source connector label. This label indicates a laser source at the optical
shows the FDA compliance label. This label shows the statement of compliance to FDA
14.8.6 MXP_MR_2.5G and MXPP_MR_2.5G Cards
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
14-117

Advertisement

Table of Contents
loading

Table of Contents