Cisco ONS 15454 DWDM Installation And Operation Manual page 522

DLP-G248 Use the Reinitialization Tool to Clear the Database and Upload Software (Windows)
Step 3 If you are using UNIX, complete the
and Upload Software (UNIX)" task on page
Stop. You have completed this procedure.
DLP-G248 Use the Reinitialization Tool to Clear the Database and Upload
Software (Windows)
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Restoring a node to the factory configuration deletes all cross-connects on the node.
Caution
Restoring a node to factory configuration on a Windows workstation should only be carried out on a
Caution
standby TCC2 card.
The TCC2 cards reboot several times during this procedure. Wait until they are completely rebooted
Note
before continuing.
Step 1 Insert the system software CD containing the reinit tool, software, and defaults database into the
computer CD-ROM drive. If the CTC Installation Wizard appears, click Cancel.
To find the recovery tool file, go to Start > Run > Browse and select the CD drive.
Step 2
On the CD drive, go to the CISCO15454 folder and choose All Files from the Files of Type drop-down
Step 3
list.
Select the RE-INIT.jar file and click Open to open the reinit tool
Step 4
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
11-6
"DLP-G249 Use the Reinitialization Tool to Clear the Database
11-8.
This procedure describes how to use the reinitialization (reinit) tool in
Windows. Use this tool to clear the database on the TCC2, upload
software, and restore factory or customer defaults.
Software CD containing Software R3.4 or later, the NE defaults, and the
reinit tool
Straight-through (CAT-5) LAN cable
JRE 1.4.2 must be installed on your PC
NTP-G103 Back Up the Database, page 11-2
As needed to clear the existing database from a TCC2 and restore the
node default settings.
Onsite
Superuser
Chapter 11 Maintain the Node
(Figure 11-3).
September 2004