Figure 11-5 Reinitialization Tool In Unix - Cisco ONS 15454 DWDM Installation And Operation Manual

Hide thumbs Also See for ONS 15454 DWDM:
Table of Contents

Advertisement

Chapter 11
Maintain the Node
Step 2
To find the recovery tool file, go to the CISCO15454 directory on the CD (usually
/cdrom/cdrom0/CISCO15454).
If you are using a file explorer, double-click the RE-INIT.jar file to open the reinit tool
Step 3
If you are working with a command line interface, run java -jar RE-INIT.jar.

Figure 11-5 Reinitialization Tool in UNIX

If the node you are reinitializing is an ENE in a proxy server network, enter the IP address of the GNE
Step 4
in the GNE IP field. If not, leave it blank.
Enter the node name or IP address of the node you are reinitializing in the Node IP field.
Step 5
If the User ID field does not contain your user ID, enter the ID. Enter your password in the Password
Step 6
field.
Verify that the Re-Init Database, Upload Package, and Confirm check boxes are checked. If any are not
Step 7
checked, check them.
In the Search Path field, verify that the path to the CISCO15454 folder on the CD-ROM drive is listed.
Step 8
Caution
Before you perform the next step, be sure you are uploading the correct database. You cannot reverse the
upload process after you click Yes.
Click Go. A confirmation dialog box appears
Step 9
Click Yes.
Step 10
The status bar at the bottom of the screen displays Complete when the node has activated the software
Step 11
and uploaded the database.
Note
Step 12
If you are logged into CTC, close the browser window and disconnect the straight-through LAN cable
from the RJ-45 (LAN) port on the TCC2 card or on the hub or switch where the ONS 15454 is physically
connected. Reconnect your straight-through LAN cable to the LAN port and log back into CTC.
September 2004
DLP-G249 Use the Reinitialization Tool to Clear the Database and Upload Software (UNIX)
The Complete message only indicates that the TCC2 successfully uploaded the database, not that
the database restore was successful. The TCC2 then tries to restore the database after it reboots.
(Figure 11-4 on page
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
(Figure
11-7).
11-5).
11-9

Advertisement

Table of Contents
loading

Table of Contents