Cisco ONS 15454 DWDM Installation And Operation Manual page 158

DLP-G41 Set Up a Windows PC for Craft Connection to an ONS 15454 Using Automatic Host Detection
Verify the operating system that is installed on your computer:
Step 1
From the Windows Start menu, choose Settings > Control Panel.
a.
Note
In the Control Panel window, double-click the System icon.
b.
On the General tab of the System Settings window, verify that the Windows operating system is one
c.
of the following: Windows 98, Windows NT 4.0, Windows 2000, or Windows XP.
Step 2 According to the Windows operating system installed on your computer, perform one of the following
steps:
For Windows 98, complete
•
• For Windows NT 4.0, complete
• For Windows 2000, complete
For Windows XP, complete
•
If you have Windows 98 installed on your PC, complete the following steps to change its TCP/IP
Step 3
configuration:
a. From the Windows Start menu, choose Settings > Control Panel.
In the Control Panel dialog box, click the Network icon.
b.
In the Network dialog box, select TCP/IP for your NIC, then click Properties.
c.
In the TCP/IP Properties dialog box, click the DNS Configuration tab and choose Disable DNS.
d.
Click the WINS Configuration tab and choose Disable WINS Resolution.
e.
Click the IP Address tab.
f.
In the IP Address window, click Specify an IP address.
g.
In the IP Address field, enter any legitimate IP address other than the node IP address as indicated
h.
on the LCD of the ONS 15454. The default IP address is 192.1.0.2.
Note
In the Subnet Mask field, type the same subnet mask as the ONS 15454. The default is
i.
255.255.255.0 (24 bit).
Click OK.
j.
In the TCP/IP dialog box, click the Gateway tab.
k.
In the New Gateway field, type the address entered in Step h. Click Add.
l.
Verify that the IP address appears in the Installed Gateways field, then click OK.
m.
When the prompt to restart your PC appears, click Yes.
n.
If you have Windows NT 4.0 installed on your PC, complete the following steps to change its TCP/IP
Step 4
configuration:
From the Windows Start menu, choose Settings > Control Panel.
a.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
2-16
In Windows XP, you can select Control Panel directly from the Start menu. Make sure you
are in Classic View before continuing with this procedure.
Step 3.
Step
Step
Step
You can suppress the LCD IP address display using CTC. For more information, see the
"DLP-G162 Change IP Settings" task on page
4.
5.
6.
9-11.
Chapter 2 Connect the PC and Log into the GUI
September 2004