Dlp-G147 View Payload Pm Parameters; Figure 8-8 Viewing Optics Performance Monitoring Information - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 8 Monitor Performance
Figure 8-8
Performance
Optics PM tab
radio buttons
radio buttons
View the PM parameter names that appear in the Param column of Current Values and History PM tabs.
Step 3
The PM parameter values appear in the Curr (current) and Prev-n (previous) columns. For PM parameter
definitions, refer to the Cisco ONS 15454 SONET and DWDM Troubleshooting Guide.
Return to your originating procedure (NTP).
Step 4

DLP-G147 View Payload PM Parameters

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the transponder or muxponder card where you want to view PM counts. The
Step 1
card view appears.
Click the Performance > Payload PM tabs
Step 2
September 2004
Viewing Optics Performance Monitoring Information
Card View
tab
Directions
Intervals
Signal-type Refresh
port menu
This task enables you to view the payload PM counts on a transponder
(TXP_MR_10G, TXP_MR_2.5G, TXPP_MR_2.5G, TXP_MR_10E),
or a muxponder (MXP_2.5G_10E, MXP_2.5G_10G) card and port to
detect possible performance problems.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
(Figure 8-9).
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
DLP-G147 View Payload PM Parameters
Auto-refresh
button menu
Clear Help
button button
8-19