Table 10-25 Txp_Mr_10G And Txp_Mr_10E Transponder Card Itu-T G.709 Threshold Settings - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 10 Change Card Settings
Table 10-24 TXP_MR_10G and TXP_MR_10E Transponder Card OTN Settings (continued)
Parameter
SD BER
Asynch/Synch
Mapping
Table 10-25

Table 10-25 TXP_MR_10G and TXP_MR_10E Transponder Card ITU-T G.709 Threshold Settings

Parameter
Port
ES
SES
UAS
BBE
FC
Table 10-26
September 2004
Description
Sets the signal degrade bit error rate.
(TXP_MR_10E only.) The card can
perform multiplexing per ITU-T G.709.
The ODUk (client SONET/SDH payload)
can be mapped to the Optical Channel
(OTUk) either asynchronously or
synchronously with this setting.
describes the values on the Provisioning > OTN > G.709 Thresholds tab.
Description
Display only. Port number.
Severely errored seconds. Two types of
thresholds can be asserted. Selecting the
SM (OTUk) radio button selects FEC and
overhead management and performance
monitoring using OTUk. Selecting the
PM radio button selects path performance
monitoring using ODUk.
Severely errored seconds
Unavailable seconds
Background block errors
Failure counter
describes the values on the Provisioning > OTN > FEC Thresholds tab.
DLP-G221 Change OTN Settings for TXP_MR_10G and TXP_MR_10E Cards
Options
• 1E-5
• 1E-6
1E-7
•
1E-8
•
1E-9
•
Asynch mapping
•
Synch mapping
•
Options
2
Numeric. Can be set for Near End or Far
End, for 15-minute or one-day intervals,
or for SM (OTUk) or PM (ODUk). Select
a bullet and click Refresh.
Numeric. Can be set for Near End or Far
End, for 15-minute or one-day intervals,
or for SM (OTUk) or PM (ODUk). Select
the bullet and click Refresh.
Numeric. Can be set for Near End or Far
End, for 15-minute or one-day intervals,
or for SM (OTUk) or PM (ODUk). Select
the bullet and click Refresh.
Numeric. Can be set for Near End or Far
End, for 15-minute or one-day intervals,
or for SM (OTUk) or PM (ODUk). Select
the bullet and click Refresh.
Numeric. Can be set for Near End or Far
End, for 15-minute or one-day intervals,
or for SM (OTUk) or PM (ODUk). Select
the bullet and click Refresh.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
10-41