Ntp-G57 Create A Logical Network Map - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 5 Turn Up Network

NTP-G57 Create a Logical Network Map

Purpose
Tools
Prerequisite Procedures This procedure assumes that network turn up is complete.
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
create the network map. If you are already logged in, continue with Step 2.
From the View menu, choose Go to Network View.
Step 2
Step 3 Change the position of the nodes in the network view according to your site plan.
a.
b.
Step 4 On the network view map, right-click and choose Save Node Position.
Click Yes in the Save Node Position dialog box.
Step 5
CTC opens a progress bar and saves the new node positions.
Note
Stop. You have completed this procedure.
November 2004
This procedure allows a superuser to create a consistent network view for
all nodes on the network.
None
As needed
Onsite or remote
Superuser
"DLP-G46 Log into CTC" task on page 2-25
Click a node to select it, then press the Ctrl key while you drag and drop a node icon to a new
location.
Repeat Step a for each node you need to position.
Retrieve, Provisioning, and Maintenance users can move nodes on the network map, but only
Superusers can save new network map configurations. To restore the view to a previously saved
version of the network map, right-click on the network view map and choose Reset Node
Position.
at a node on the network where you want to
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
NTP-G57 Create a Logical Network Map
5-15