Table 1-1 Pin Connection Of The Power Fmecs - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP- G17 Connect Office Power to the ONS 15454 ETSI
If the system loses power or if both TCC2 cards are reset, you must reset the ONS 15454 ETSI clock.
Note
After powering down, the date defaults to January 1, 1970, 00:04:15. To reset the clock, see the
"NTP-G24 Set Up Name, Date, Time, and Contact Information" procedure on page
Verify that the MIC-A/P FMEC card is installed in Slot 23 and the MIC-C/T/P FMEC card is installed in
Step 1
Slot 24 of the EFCA.
Attach the connector on the end of the power cable to the power FMEC.
Step 2
Tighten the screws of the connector on the power cable.
Step 3
Connect the power cable to the fuse panel or power source. Use the pin connections in
Step 4
conductor (green with yellow stripes) is used for secondary grounding such as grounding to the rack.
Table 1-1
Pin
A1
A2
A3
Return to your originating procedure (NTP).
Step 5
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
1-36
Pin Connection of the Power FMECs
Function
Battery return
–48 V battery
Ground
Chapter 1 Install the Shelf and Common Control Cards
Cable Color
Black
Red
Green with yellow stripes
3-6.
Table 1-1. The
September 2004