Dlp-G257 Place Band Oadm Ports Out Of Service; Dlp-G258 Place Channel Oadm Ports Out Of Service - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G257 Place Band OADM Ports Out of Service

DLP-G257 Place Band OADM Ports Out of Service
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
On the shelf graphic in CTC, double-click the AD-1B-xx.x or AD-4B-xx.x card with the ports you want
Step 1
to put out of service.
Click the Provisioning > Optical Line > Parameters tabs.
Step 2
Under Admin State, choose OOS,DSLB for each port that does not have an OOS-MA,DSLB service
Step 3
state.
Step 4 Click Apply.
In the confirmation dialog box, click Yes.
Step 5
Click the Provisioning > Optical Band > Parameters tabs.
Step 6
Under Admin State, choose OOS,DSLB for each port that does not have an OOS-MA,DSLB service
Step 7
state.
Click Apply.
Step 8
In the confirmation dialog box, click Yes.
Step 9
Return to your originating procedure (NTP).
Step 10

DLP-G258 Place Channel OADM Ports Out of Service

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
On the shelf graphic in CTC, double-click the AD-1C-xx.x, AD-2C-xx.x, or AD-4C-xx.x card with the
Step 1
ports you want to put out of service.
Step 2 Click the Provisioning > Optical Line > Parameters tabs.
Under Admin State, choose OOS,DSLB for each port that does not have an OOS-MA,DSLB service
Step 3
state.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
11-18
This task places the AD-1B-xx.x and AD-4B-xx.x card ports out of
service in preparation for card removal.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
This task places the AD-1C-xx.x, AD-2C-xx.x, and AD-4C-xx.x card
ports out of service in preparation for card removal.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Chapter 11 Maintain the Node
September 2004