Dlp-G186 Delete An Osc Termination; Dlp-G187 Delete A Provisionable Patchcord - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G186 Delete an OSC Termination

DLP-G186 Delete an OSC Termination
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution Deleting a OSC termination might cause node isolation and loss of visibility to nodes that do not have
other OSCs or network connections to the CTC computer.
Click the OSC tab.
Step 1
Click the OSC termination you want to delete and click Delete.
Step 2
Step 3 In the Delete OSC Termination confirmation box, click Yes. Confirm that the changes appear; if not,
repeat the task.
Until all network OSC terminations are deleted, loss of signal (LOS) or power failure alarms on the
Optical Booster (OPT-BST) amplifier, OSCM card, and OSC-CSM card might appear.
Return to your originating procedure (NTP).
Step 4

DLP-G187 Delete a Provisionable Patchcord

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Deleting the GCC termination on a port also deletes the provisionable patchcord link on the port.
Note
In node view, click the Provisioning > Comm Channels > Provisionable Patchcords tabs. If you are
Step 1
in network view, click Provisioning > Provisionable Patchcords tabs.
Click the provisionable patchcord that you want to delete.
Step 2
Click Delete.
Step 3
In the confirmation dialog box, click Yes.
Step 4
Return to your originating procedure (NTP).
Step 5
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
9-30
This task deletes an OSC termination on the ONS 15454.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
This task deletes a provisionable patchcord.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning and higher
Chapter 9 Manage the Node
September 2004