Dlp-G212 Change Optical Channel Parameters For The 32Wss Card; Table 10-14 32Wss Optical Channel Parameter Settings - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 10 Change Card Settings

DLP-G212 Change Optical Channel Parameters for the 32WSS Card

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the 32WSS card where you want to change the optical channel parameter
Step 1
settings.
Click the Provisioning > Optical Chn: Optical Connector tab for one of the four optical channel:
Step 2
optical connector tabs (1 to 4) that are available.
Step 3 Modify any of the settings described in

Table 10-14 32WSS Optical Channel Parameter Settings

Parameter Description
Port Display only. Port designation information.
Each Optical Channel has a unique receive (RX)
and a pass-through (PT) port in this field. For
example, with the first two ports of Optical Chn:
Optical Connector 1 are designated as
1 CHAN-16-1-RX and 33 CHAN-16-1-PT.
These ports are shown in the 32WSS display
windows in top row of ADD RX ports as 01 and
33.
Port Name The user can assign a logical name for each of
the ports shown by filling in this field.
Admin State Sets the port service state unless network
conditions prevent the change. For more
information about administrative states, see
Appendix C, "DWDM Enhanced State Model."
Service State Identifies the autonomously generated state that
gives the overall condition of the port. Service
states appear in the format: Primary
State-Primary State Qualifier, Secondary State.
For more information about service states, see
Appendix C, "DWDM Enhanced State Model."
September 2004
DLP-G212 Change Optical Channel Parameters for the 32WSS Card
This task changes the optical channel parameter settings for the 32WSS
card.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Table 10-14.
Options
—
User-defined. Name can be up to 32 alphanumeric/special
characters. Blank by default.
See the
•
page
IS/Unlocked
•
IS,AINS/Unlocked,automaticInService
•
OOS,DSBLD/Locked,disabled
•
OOS,MT/Locked,maintenance
•
IS-NR/Unlocked-enabled
•
OOS-AU,AINS/Unlocked-disabled,automaticInService
•
• OOS-MA,DSBLD/Locked-enabled,disabled
OOS-MA,MT/Locked-enabled,maintenance
•
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
"DLP-G104 Assign a Name to a Port" task on
6-8.
10-23