Removing The Original Width Sensor Board , The Original Length Sensor , And Trailing Edge Sensor - Riso RZ9 Series Technical Manual

CHAPTER 14: Duplex AF Unit
3. Removing the Original Width Sensor Board , the Original Length Sensor , and Trailing Edge
Sensor
(1) Open the original table.
(2) Remove the upper part of the table (3 screws).
(3) Disconnect the connectors and remove the original width sensor board , original length sensor 1/2 , and
trailing edge sensor.
Note:
To ensure proper detection of paper size , after wiping off the sensor board and terminal plate with a dry cloth
(or cloth with alcohol) , apply silicone grease(KS-660) to the terminal plate.
Original Table
1416
Terminal Plate
1403
DANKA AUSTRALIA PTY. LTD.
Original Trailing Edge
Sensor
[ 14 - 10 ] - Rev. 0.2
Original Width Sensor Board
Original Length Sensor 1
Original Length Sensor 2
1417
RZ9 Series