Debug Ip Bgp Dampening - Dell S6000 Reference Manual

show debugging

debug ip bgp dampening

View information on routes being dampened.
S6000
Syntax
debug ip bgp [vrf test | ipv4 {unicast | multicast} | ipv6
{unicast | multicast} dampening
To disable debugging, use the no debug ip bgp ipv4 multicast dampening
command.
Parameters
dampening
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Version 7.6.1.0
debug ip bgp events
Display information on local BGP state changes and other BGP events.
S6000
Syntax
debug ip bgp [ip-address | peer-group peer-group-name] events
[in | out]
To disable debugging, use the no debug ip bgp [ip-address | peer-group
peer-group-name] events command.
Border Gateway Protocol
— views enabled debugging operations.
Enter the keyword dampening to debug route flap
dampening information.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced IPv6 MGBP support for the E-Series.
353