Dell S6000 Reference Manual page 352

events
ipv4
ipv6
keepalives
notifications
soft-
reconfiguration
updates
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
To view information on both incoming and outgoing routes, do not include the in
Information
and out parameters in the debugging command. The in and out parameters
cancel each other; for example, if you enter the debug ip bgp in command and
then enter the debug ip bgp out command, you do not see information on the
incoming routes.
Entering a no debug ip bgp command removes all configured debug
commands for BGP.
Related
debug ip bgp events
Commands
debug ip bgp keepalives
debug ip bgp notifications
debug ip bgp updates
352
Enter the keyword events to view BGP protocol events.
Enter the ipv4 IP address to view the IPV4 route information.
Enter the ipv6 IP address to view the IPV6 route information.
Enter the keyword keepalives to view BGP keepalives.
Enter the keyword notifications to view BGP
notifications.
Enter the keywords soft-reconfiguration to view only
information on inbound BGP soft reconfiguration.
Enter the keyword updates to view BGP updates.
Added support for VRF.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
— views information about BGP events.
— views information about BGP keepalives.
— views information about BGP notifications.
— views information about BGP updates.
Border Gateway Protocol