Neighbor Fall-Over - Dell S6000 Reference Manual

Parameters
ip-address
peer-group-
name
ttl
Defaults Disabled.
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage To prevent loops, the neighbor ebgp-multihop command does not install the
Information default routes of the multihop peer. Networks not directly connected are not
considered valid for best-path selection.

neighbor fall-over

Enable or disable fast fall-over for BGP neighbors.
S6000
Syntax
neighbor {ipv4-address | peer-group-name} fall-over
To disable, use the no neighbor {ipv4-address | peer-group-name}
fall-over command.
Parameters
ipv4-address
peer-group-
name
Border Gateway Protocol
Enter the IP address of the neighbor in dotted decimal
format.
Enter the name of the peer group.
(OPTIONAL) Enter the number of hops as the Time to Live
(ttl) value. The range is from 1 to 255. The default is 255.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Enter the IP address of the neighbor in dotted decimal
format.
Enter the name of the peer group.
369