Parameters
peer-group-
name
Defaults
Not configured.
Command
ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
When you create a peer group, it is disabled (Shut mode).
Information
Related
neighbor peer-group (assigning peers)
Commands
neighbor remote-as
group.
neighbor shutdown
neighbor peer-group passive
Enable passive peering on a BGP peer group, that is, the peer group does not send an OPEN message,
but responds to one.
S6000
Syntax
neighbor peer-group-name peer-group passive [sessions]
To delete a passive peer-group, use the no neighbor peer-group-name
peer-group passive command.
Parameters
peer-group-
name
376
Enter a text string up to 16 characters long as the name of
the peer group.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
— assigns routers to a peer group.
— assigns a indirectly connected AS to a neighbor or peer
— disables a peer or peer group.
Enter a text string up to 16 characters long as the name of
the peer group.
Border Gateway Protocol