Dell S6000 Reference Manual page 372

maximum
threshold
warning-only
Defaults threshold = 75
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage If you configure the neighbor maximum-prefix command and the neighbor
Information
receives more prefixes than the neighbor maximum-prefix command
configuration allows, the neighbor goes down and the show ip bgp summary
command displays (prfxd) in the State/PfxRcd column for that neighbor. The
neighbor remains down until you enter the clear ip bgp command for the
neighbor or the peer group to which the neighbor belongs or you enter the
neighbor shutdown and neighbor no shutdown commands.
Related show ip bgp summary
Commands
372
Enter a number as the maximum number of prefixes allowed
for this BGP router. The range is from 1 to 4294967295.
(OPTIONAL) Enter a number to be used as a percentage of
the maximum value. When the number of prefixes reaches
this percentage of the maximum value, the E-Series software
sends a message. The range is from 1 to 100 percent. The
default is 75.
(OPTIONAL) Enter the keyword warning-only to set the
router to send a log message when the maximum value is
reached. If this parameter is not set, the router stops peering
when the maximum number of prefixes is reached.
NOTE: When you set this option, the router accepts BGP
prefixes only until the maximum configured value. After
the maximum number is reached, the router drops any
additional prefixes that it receives.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
— displays the current BGP configuration.
Border Gateway Protocol