Dell S6000 Reference Manual page 310

Command BOOT_USER
Modes
Command
Version 9.0.2.0
History
Usage
After entering the boot change command and selecting the parameters, press
Information
Enter. The software prompts you to enter the following:
•
Note When you enter a new parameter that extends beyond 80 characters, you
cannot use the Backspace key to correct any mistakes. If you make a mistake, you
must re-enter the parameter.
Note: You must set the IP address of the designated download port before you
execute this command. Otherwise, an second statement message alerts you that
the configuration cannot proceed.
shows the first field after you enter boot change primary. At this point:
•
•
Example
BOOT_USER # boot change primary
boot device : ftp
shows the completed command:
BOOT_USER # boot change primary
'.' = clear field; '-' = go to previous field
boot device : ftp
file name : tt/latestlabel
Server IP address : 10.16.1.200
username : amsterdam
password : ******
BOOT_USER #
To view the current boot configuration, use the show bootvar command.
Related boot_zero
Commands
show_bootvar
310
Introduced on the S6000.
The boot device (flash, ftp, tftp, or usbflash), image file name, IP address of the
server containing the image, username, and password (only for ftp).
Press Enter to accept the information already configured, or
Change that information. To do so, press the . (period) key and enter new
information. After you enter the information, press Enter.
— Remove the primary, secondary, or default boot image configuration.
— Display boot configuration information.
Boot Command Line Interface