Dell S6000 Reference Manual page 392

Parameters
process-id
match external
{1 | 2}
match internal
route-map
map-name
Defaults Not configured.
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
Version 7.8.1.0
Version 7.7.1.0
Usage
You can use the redistribute command to advertise the IGP cost as the MED
Information
on redistributed routes. When you set the route-map with metric-type internal and
apply outbound to an EBGP peer/peer-group, the advertised routes corresponding
to those peer/peer-groups have the IGP cost set as MED.
When you enter the redistribute isis process-id command without any
other parameters, Dell Networking OS redistributes all OSPF internal routes,
external type 1 routes, and external type 2 routes. RFC does not support this
feature.
392
Enter the number of the OSPF process. The range is from 1
to 65535.
(OPTIONAL) Enter the keywords match external to
redistribute OSPF external routes. You can specify 1 or 2 to
redistribute those routes only.
(OPTIONAL) Enter the keywords match internal to
redistribute OSPF internal routes only.
(OPTIONAL) Enter the keywords route-map then the name
of a configured route map.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced the ability to substitute IGP cost for MED when a
peer/peer-group outbound route-map is set as internal.
Introduced on the S-Series.
Introduced on the C-Series.
Border Gateway Protocol