Dell S6000 Reference Manual page 334

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
To accept 4-byte formats before entering a 4-byte AS number, configure your
Information
system. All the routers in the Confederation must be 4 byte or 2 byte identified
routers. You cannot mix them.
The autonomous systems configured in this command are visible to the EBGP
neighbors. Each autonomous system is fully meshed and contains a few
connections to other autonomous systems. The next hop, MED, and local
preference information is preserved throughout the confederation.
Dell Networking OS accepts confederation EBGP peers without a LOCAL_PREF
attribute. The software sends AS_CONFED_SET and accepts AS_CONFED_SET and
AS_CONF_SEQ.
If a local-as is configured, BGP does not allow for the configuration of BGP
confederation. Similarly, if BGP confederation is configured, then BGP does not
allow the configuration of local-as.
If the neighbor is an eBGP neighbor, then BGP performs a check on the first AS
number. In this scenario, it is mandatory that the first sequence in the AS path is of
type AS_SEQUENCE or AS_CONFED_SEQUENCE (in the case of confederations). If
the first entry appears as an AS_CONFED_SET and the neighbor is not in the local
AS, then this is strictly a problem with the neighbor node.
This command automatically restarts the BGP instance for the configuration to
take effect.
Related
bgp four-octet-as-support
Commands
334
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series. Added support for the 4-byte
format
— enables 4-byte support for the BGP process.
Border Gateway Protocol