Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 1366

output definitions
Destination
Gateway
State
Metric
Proto
-> show ip rip routes 2.0.0.0 255.0.0.0
Destination
Mask length
Gateway(1)
Protocol
Out Interface
Metric
Status
State
Age
Tag
Gateway(2)
Protocol
Out Interface
Metric
Status
State
Age
Tag
output definitions
Destination
Mask length
Gateway
Protocol
Out Interface
Metric
Status
State
Age
Tag
page 33-26
Destination network IP address.
The Gateway IP address (switch from which the destination address
was learned).
The associated state of the route, which can be A (Active), H
(Holddown), or G (Garbage).
Metric associated with this network. Generally, this is the RIP hop
count (the number of hops from this switch to the destination switch).
The type of route (Local, Rip, or Redist).
= 2.0.0.0,
= 8,
= 5.0.0.14,
= Rip,
= intf5,
= 2,
= Installed,
= Active,
= 19s,
= 0,
= 4.0.0.7,
= Rip,
= intf4,
= 3,
= Not Installed,
= Active,
= 12s,
= 0,
Destination network IP address.
Length of the destination network IP subnet mask.
The Gateway IP address (switch from which the destination address
was learned).
The type of the route (Local, Rip, or Redist).
The RIP interface through which the next hop is reached.
Metric associated with this network. Generally, this is the RIP hop
count (the number of hops from this switch to the destination switch).
The RIP interface status (Installed or Not Installed).
The associated state of the route (Active, Holddown, or Garbage).
The age of the route in seconds (the number of seconds since this route
was last updated or otherwise determined to be correct).
The associated route tag.
OmniSwitch 6250 CLI Reference Guide
RIP Commands
November 2009